This kit comes with everything you need to replace your Current Bed Support Rodends
2- 3/8" NF RH Rodend
2- 3/8" NF LH Rodend
2- 3/8 NF RH Nuts
2- 3/8 NF LH Nuts

NOTE:
For Extreme Weather Conditions we recommend to coat the rod ends with a clear coat paint and Anti-Seize the threads. '
At Check Out Use flat rate envelope for shipping

+14 dodge ram rear light brackets (No drill)

Mount your Rigid or Knockoff 10″ or 20″ LED in between your bumper opening. Complete Bolt on behind Tow Hooks. Comes With new 3/8″ Stainless mounting Hardware. Mount is made out of 1/4″ steel and 2 stage Powder Coated Black. USA Made!

Pre-load bed support’s mount on the rear bed posts next to the tailgate with flag mount. LH/RH rod ends allow the support rod to pre load the bed post. This will help keep your tailgate from falling off and the bed post cracking during heavy off road use. Pull pins hold the support rods and allow for quick removal for loading the truck bed. Mounts are made of 3/16″ HR Steel, Rods are Aluminum threaded 3/8″ NF. Rods and mounts come Powdered coated Semi Gloss Black. All hardware included for mounting. Drilling is required and the rear tail lights removed to gain access to the lower mounting bolt. If your truck has a factory installed 5th wheel trailer plug mounted on the rear post this product will not work. Install time is 45 mins. Available for 3rd and 4th Gen. Dodges.

For 2500/3500 03-18 Dodge Rams

Bolts Under Tow Hooks, No Drilling, 1/4 Cold Roll Steel Brackets, 1 3/4″ .120 wall Tubing, Laser Cut HID Light Tabs (Works for any Light), Mount UP to 9″ Lights, Comes With New Stainless Steel Bolts, Nylock Nuts.
For 03-12 Dodge Rams,Doesn’t Fit Sport Models, Tow hooks still can be used, Although pulling to the left and right with both hooks at the same time is limited.

3-18 2500/3500 Dodge Ram 2 Tab All In One Light Bar

New Design. Lights sit with top of bumper and Reversed Tab’d for better light protection. The center of the light bar now has mounting holes to run a 10″/20″ LED. Current setup is for Baja Designs Stealth series.

Bolts Under Tow Hooks, No Drilling, 1/4 Laser Cut Steel Bracket, 1 3/4″ .120 Wall Tubing, Laser Cut HID Light Tabs (Works for any Light), Mount UP to 9″ Lights, Comes With New Stainless Steel Bolts, Nylock Nuts.

For 03-18 Dodge Rams,Doesn’t Fit Sport Models, Tow hooks still can be used, Although pulling to the left and right with both hooks at the same time is limited.

03-18 2500/3500 Dodge Ram All In One Light Bar

New Design. Lights sit with top of bumper and Reversed Tab’d for better light protection. The center of the light bar now has mounting holes to run a 10″/20″ LED. Current setup is for Baja Designs Stealth series

Bolts Under Tow Hooks, No Drilling, 1/4 Laser Cut Steel Bracket, 1 3/4″ .120 Wall Tubing, Laser Cut HID Light Tabs (Works for any Light), Mount UP to 9″ Lights, Comes With New Stainless Steel Bolts, Nylock Nuts.

For 03-15 SLT Dodge Rams,Doesn’t Fit Sport Models, Tow hooks still can be used, Although pulling to the left and right with both hooks at the same time is limited.